CUSTOMER THOUGHT THEY HEARD WHAT WAS A GRINDING NOISE WHILE DRIVING HOWEVER COULD NOT PIN POINT WHAT WAS THE ISSUE. I ONLY HEARD GRINDING WHILE DRIVING BUT FOUND THAT THE UNDERSHIELD SCRAPES AGAINST THE FLOOR DUE TO BROKEN CLIPS. REATTACHED UNDERSHIELD AND FOUND THAT THERE IS NO LONGER ANY GRINDING/ SCRAPING NOISE. ADJUSTED PARK BRAKE CABLE ASSEMBLY AT THE HANDLE ADJUSTER.
John T. gave our service a 5 star review on 6/11/2023
P0171 SYSTEM TOO LEAN (BANK 1) P0101 MASS AIR FLOW CIRCUIT RANGE / PERFORMANCE Vehicle was brought in to diagnose a CEL on the dash board. Vehicle contained these codes that are listed above. Inspected air intake system near the mass air flow sensor/ meter and found that one of the vacuum lines was disconnected. Customer stated they recently had taken vehicle to other shop for an oil change service. Customer stated light illuminated after previous service. Plugged in vacuum hose that connects to air intake hose. Cleaned mass air flow sensor to be on the safe side and cleared codes. Monitored engine data while running and found that there are no issues with the mass air flow sensor and codes have not returned.
Joyce W. gave our service a 5 star review on 5/11/2023
Found noise upon left turns. During inspection I found that there is a torn cv axle boot on the driver side. There is little to no grease inside the axle boot. Due to the boot being torn the cv axle flexes outside of its normal turn radius causing a clicking sound. R&R cv axle as an assembly. Ensured all removed components were reinstalled correctly. Test drove and verified repair. There is no longer any noise present upon turning.
Miguel P. gave our service a 5 star review on 9/4/2022
Test drove vehicle and found no drive ability concerns with the braking system. Raised vehicle and inspected braking system including front and rear pads/ shoes & rotors/ drums. Found no leaks in the system. Found no damaged components. Front pads are still above 80% thickness rotors are ok. Rear Brake shoes are above 50% thickness and drums are ok. Found no issues in the braking system.
Mark D. gave our service a 5 star review on 6/16/2022
Changed engine oil. Upon replacement of oil filter the under vehicle cover had to be removed to gain access to the oil filter housing. Found that the oil filter housing cover had been over tightened and was cracked resulting in the cover slightly leaking oil. R&R oil filter housing cover. New cover is aluminum when the old housing cover was plastic. Visually inspected all fluids, belts, hoses, brakes and tires. All visuals, except tires, are within manufacturer specifications at this time. Topped off fluids. Recommend tire replacement. Set tire psi to manufacturer specifications. Reset maintenance light and placed new oil change reminder sticker in windshield.
Cindy F. gave our service a 5 star review on 1/12/2022